Communication modules

make possible the automatic monitoring of the UPS standard statuses (fail of the supply network, overload on the UPS output, low accumulator voltage) at the computer, connected through RS 232C serial line
in co-operation with software periodically notify connected users about nonstandard status of power supply, the time of server's stop, backup to standard status, make operation system and UPS shutdown in the cases of reservation time end or critical status of accumulator
automatic restart after power supply regeneration
automatic restart of the power supply environments through the command on the abort of the output potential
in co-operation with signals distributor UR3 make possible the distribution of the UPS state signals for the most types of servers
make possible the connection with SNMP adapter and the distributing of the UPS state information to computer network with its help

make possible to signal about UPS standard statuses through open collectors (can be used for switching of the LED indicators, for digital input of industry automats and so on)
make possible the UPS shutdown or restart by power supply signal

make possible standard connection with Windows NT server and correct work of operation system

converter of serial line into frequency dependent signal transmitted through infradiode
it processes two UPS statutes (blackout / low battery voltage)

converter designed for conversion of serial link RS 232 signals into signals of RS 422 or 485 links

automatic converter RS 232/485 with voltage stabilizers

signals distributor (concentrator) of UR2 signals is designed to monitor the UPS activity
merges four RS 232 serial links into one RS 232 (eventually RS 422 or RS 485) and vice versa
enables to connect up to four devices with a serial link to the server. Devices can be of different types. However, they must be able to communicate in MASTER (server) - SLAVE (UPS) mode

signal distributor / concentrator of 8 serial links RS 232 or RS422, convertor RS 232/422

module enables to scan up to 20 status signals and transfer them into serial link for Globmon monitoring program
contains HUB of two RS 232 links what enables to connect another equipment to monitoring without additional modules

statutes outputs for UPS of PSN series

20 binary statutes of contacts scanning and filtration of scanned statutes
built-in isolated power supply for contacts scanning
scanning of analog values limits
5 programmable signalling relays
40 scanned analog values

scanning of 4 binary contacts’ statuses and filtration of scanned statutes
analog values limits scanning
1 programmable signalling relay
4 scanned analog values, 2 probes of external temperature and 1 probe of internal temperature
wide range of input voltage

single or three phased mains monitoring with neutral wire
fault will be indicated if a value of measured parameter is out of limits defined by user
fault indicating (communication line RS 485 / statuses contacts relay)

Network adapters enable network management of UPS units, DC power supplies, switchboards, generating sets or other devices. Via these adapters can network control stations monitor various statutes of connected devices.

network management of UPS, DC power supplies, generating sets, etc.
connection to ethernet 10/100 baseT
configuration through telnet, terminal
protection against latching
wide range of DC supply, supplied by 230V mains
choice of mechanical version

connection to ethernet 10/100 baseT
configuration through ethernet
connection of several monitored PC and devices at the same time
supports fast fault statuses forwarding
wide range of DC supply, supplied by 230V mains
version with external network adapter (UM10D, UM10ID) or with built-in DC power supply in 19“ rack 1U (UM10D RDC)


	Home page Company Products Services Contact Cooperation Cogeneration